The industrial steam cleaning equipment category on our product pages carries ten cleaning machines, and each one names the jobs it is put to. If you are buying for a fleet yard, a service bay or a workshop, the fastest way to shortlist is to read what each machine is listed for, then check the published specification against the power, water and floor space you actually have.
What the product pages state, model by model
The fixed machine: vehicle exteriors, interiors and engine bays
The overview text for the Fixed Steam Cleaning Machine PowerDe HW02 names three tasks directly: cleaning vehicle exteriors at gas stations and parking lots, vacuuming and disinfecting interiors, and cleaning the engine compartment. Its specification table is the most complete in the category — 6 kW heating power, 160° steam temperature, 0.8 MPa vapour pressure, an 80 L SUS304 tank, a footprint of 1,200 × 800 × 1,200 mm including handles, a tap-water inlet with a 4-point internal-tooth 1/2 inch joint, dry and wet steam modes with a vacuum cleaner, and a 220 V working voltage. The same listing also names leakage, short-circuit, high-temperature, high-voltage and water-shortage protection among the safety designs.
The driving style machines: garages and narrow parking bays
The PWD02, PWD01 and HMW2 models are listed as mobile active-water cleaning machines with three modes — dry steam, wet steam and hot water — and the listings place them mainly in indoor garages and the tight spaces between outdoor parking bays. The PWD02 page adds a PTC semiconductor heater, a 60 L clean water tank and an autonomous-driving mode of movement, with vacuum suction through a flat nozzle into a sewage tank. The same three models are sold both with and without a battery, so a buyer who already has compatible packs can order the bare unit.
The hand-pushed machines: beds and medical machinery
The hand-pushed HMW3 is described as a high-temperature, high-pressure machine that switches between dry and wet steam. Its listing states the current use directly: cleaning and disinfecting hospital beds and medical machinery. The published figures for the hand-pushed medical equipment steam cleaning machine are a footprint of 1,150 × 520 × 1,030 mm, a 4.5 kW PTC semiconductor heater, a 50 L clean water tank, a 48 V battery as working power supply, and cleaning through a high-pressure water gun with a nozzle.
The remaining listings in the category are variants rather than new machine types: battery and no-battery versions of the models above, plus a fixed 220 V model described with the same hospital-bed and medical-machinery applications. Read the category page as three machine types in ten purchase configurations.
Matching those applications to your site
- Permanent washing point. Where mains power and a tap already exist, a fixed machine is the simpler install, and the 220 V and tap-water inlet figures on the page tell you whether your supply matches.
- Long working radius. Driving style models fit yards where the operator moves the machine along a row of vehicles instead of dragging a hose the whole way.
- Shared or power-poor areas. Battery-fed hand-pushed units work where there is no 220 V point near the task and the machine has to be stopped and repositioned often.
- Task type. Engine-bay and interior work leans on dry steam; heavy road grime leans on the hot water mode offered by the driving style models.
Figures the pages do not publish
Steam output per hour, battery capacity and run time, hose and wand lengths, machine weight, noise level and the accessory list are not on these pages. Those numbers decide how many vehicles one operator can finish in a shift, so request them in writing with your quotation. Also confirm the model designation on the order: one fixed listing is headed with an HW03 model number while its description text uses an HMW3 label, so a written confirmation removes the ambiguity.
Next step
Send us the layout of your yard or bay, the position of power and water, and the vehicles or equipment you clean. We will map that against the applications and specifications on each product page and recommend the configuration that fits. Use the contact page or email sales@powerde.net.
